Wen GN9500 Instruction Manual page 19

BEFORE STARTING THE GENERATOR
1. Verify that generator is outside on a dry, level surface with at
least two feet of clearance on all sides.
2. To maximize safety, check that the generator is properly
grounded (see "Ground the Generator").
3. Check there is sufficient level of oil in the crankcase. Add oil
if necessary (see "Add / Check Oil").
4. Make sure there is sufficient level of gasoline in the fuel tank.
Add fuel if necessary (see "Add / Check Fuel").
5. Make sure all electrical devices are unplugged from the gen-
erator during ignition. Otherwise it will be difficult for the en-
gine to start.
STARTING THE GENERATOR
1. Turn the fuel valve (Fig. 11) to the ON position.
2. Move choke lever (Fig. 12) to the CLOSE / START position.
a. To start the engine with electric starter:
3. Insert the key and turn the engine switch to the
START position for 2-3 seconds.
NOTE: If the engine does not start, release the switch
and try again. Keeping the switch in the START posi-
tion too long can damage the starter.
4. When engine starts, release the switch to ON.
5. Slowly move choke lever to the OPEN/RUN posi-
tion. If engine fires, but does not continue to run,
move choke lever to CLOSE / START position and re-
peat starting instructions.
NOTE: If the engine is warm place the choke
lever on OPEN / RUN
To start your generator using remote start,
see the next page.
6. Allow the engine to run for several minutes before attempting to connect any electrical devices. This allows the
generator to stabilize its speed and temperature. Follow the instructions in the "Using Your Generator" section for
properly connecting your electrical devices.
NOTE: In case you have had repeated failed attempts to start the engine, please consult the troubleshooting guide
before attempting to start the generator. If problems persist please call 1-(800) 232-1195, M-F 8-5 CST.
STARTING YOUR GENERATOR
b. To start the engine with recoil starter:
3. Turn the engine switch to the ON position.
4. Pull on the recoil starter handle slowly until a slight
resistance is felt, then pull quickly to start the engine.
Return cord gently into the recoil starter. Never allow
the cord to snap back.
If engine fails to start, repeat this step.
5. Once the engine has started, slowly return the
choke lever all the way to the OPEN / RUN position.
Fig. 11
Fig. 12
19