Cleaning And Lubricating The Drive Chain; Checking And Lubricating The Cables; Checking And Lubricating The Throttle Grip And Cable End - Yamaha Jupiter Fi T115FS-5 Owner's Manual

Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Remove all dirt and mud from the
drive chain with a brush or cloth.
TIP
For a thorough cleaning, have a
Yamaha dealer remove the drive chain
and soak it in solvent.
2. Spray Yamaha chain lubricant or
other suitable chain lubricant on
the entire chain, making sure that
all side plates and rollers have
been sufficiently oiled.
Periodic maintenance and adjustment
EAU23018
Checking and lubricating the
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the ca-
bles and cable ends should be lubri-
cated if necessary. If a cable is
damaged or does not move smoothly,
have a Yamaha dealer check or re-
ECA10584 place it. WARNING! Damage to the
outer housing of cables may result
in internal rusting and cause inter-
ference with cable movement. Re-
place damaged cables as soon as
possible to prevent unsafe condi-
tions.
[EWA10712]
Recommended lubricant:
Yamaha cable lubricant or other
suitable cable lubricant
7-24
EAU23098
Checking and lubricating the
throttle grip and cable end
The operation of the throttle grip
should be checked before each ride. In
addition, the cable end should be lubri-
cated by a Yamaha dealer at the inter-
vals specified
maintenance chart.
The throttle cable is equipped with a
rubber cover. Make sure that the cover
is securely installed. Even though the
cover is installed correctly, it does not
completely protect the cable from wa-
ter entry. Therefore, use care not to
pour water directly onto the cover or
cable when washing the vehicle. If the
cable or cover becomes dirty, wipe
clean with a moist cloth.
EAUE1191
in the periodic
7