Rear Wheel - Yamaha Jupiter Fi T115FS-5 Owner's Manual

Periodic maintenance and adjustment
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the retainer
in the speedometer gear unit fits over
the slot on the fork leg.
7
ZAUV0372
1. Retainer
2. Slot
3. Insert the wheel axle, and then in-
stall the washer and the axle nut.
4. Take the motorcycle off the cen-
terstand so that the front wheel is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
40 Nm (4.0 m·kgf, 29 ft·lbf)
TIP
When tightening the axle nut, hold the
wheel axle with a wrench to keep it
from turning.
6. While applying the front brake,
push down hard on the handle-
bars several times to check if the
front fork compresses and re-
2
1
bounds smoothly.
7. Connect the speedometer cable.

Rear wheel

To remove the rear wheel
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Remove the lower drive chain cov-
2. Loosen the axle nut.
1. Axle nut and washer
2. Drive chain slack adjusting nut
3. Locknut
4. Brake torque rod nut
7-33
WARNING
er by removing the screw.
2
3
1
4
EAU25081
EAU57220
EWA10822