Replacing The Air Filter Element And Cleaning The Check Hoses - Yamaha Jupiter Fi T115FS-5 Owner's Manual

several minutes, turn the engine
off immediately and consult a
Yamaha dealer for inspection.
11. After checking the oil pressure,
tighten the bleed bolt with the
specified torque.
Tightening torque:
Bleed bolt:
7 Nm (0.7 m·kgf, 5.2 ft·lbf)
12. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
13. Turn the engine off, check the oil
level and correct it if necessary.
Periodic maintenance and adjustment
Replacing the air filter ele-
ment and cleaning the check
hoses
The air filter element should be re-
placed at the intervals specified in the
periodic maintenance and lubrication
chart. Replace the air filter element
more frequently if you are riding in un-
usually wet or dusty areas. In addition,
the air filter check hoses must be fre-
quently checked and cleaned if neces-
sary.
To replace the air filter element
1. Remove the air filter case cover by
removing the screws.
1
2
ZAUV0345
1. Air filter
2. Air filter case cover
7-14
EAUB1282 2. Pull the air filter element out.
3. Insert a new air filter element into
the air filter case as shown.
NOTICE: Make sure that the air
filter element is properly seated
in the air filter case. The engine
should never be operated with-
out the air filter element in-
stalled, otherwise the piston(s)
and/or cylinder(s) may become
excessively worn.
ZAUV0346
1. Air filter element
4. Install the air filter case cover by
installing the screws.
To clean the air filter check hoses
1. Check the hoses shown for accu-
mulated dirt, water or oil.
[ECA10482]
1
7