Yamaha Jupiter Fi T115FS-5 Owner's Manual page 48

Periodic maintenance and adjustment
2
1
ZAUV0343
1. Bolt
2. Oil filter element cover
6. Remove and replace the oil filter
element and O-rings.
7
2
ZAUV0344
1. Oil filter element
2. O-ring
7. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.4 ft·lbf)
TIP
Make sure that the O-rings are properly
seated.
8. Install the oil drain bolt and then
tighten it to the specified torque.
1
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
9. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
7-13
Recommended engine oil:
See page 9-1.
Oil quantity:
Without oil filter element replace-
ment:
0.80 L (0.85 US qt, 0.70 Imp.qt)
With oil filter element replacement:
0.85 L (0.90 US qt, 0.75 Imp.qt)
NOTICE
 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD". Make sure that
the engine oil doesn't contain
friction-reducing additives.
 Make sure that no foreign mate-
rial enters the crankcase.
NOTICE
After changing the engine oil, be
sure to check the oil pressure as de-
scribed below.
10. Remove the bleed bolt, start the
engine and keep it idling until oil
flows out. If no oil comes out after
ECAW0033
ECA10441