[Uv/Mode]; [Lamp/Fm]; F+[Menu/Lock]; F+[Uv/Mode] - Baofeng UV-3R Mark II Reference

[UV/MODE]

Momentarily press to switch the VFO between UHF Mode
and VHF Mode.
Press and Hold to switch between VFO and Memory.

[LAMP/FM]

Momentarily press to light the Torch.
Press and Hold to activate or deactivate the FM Radio
function.

F+[MENU/LOCK]

Press the F/ALERT], then press [MENU/LOCK], to
Activate Scanning Function.

F+[UV/MODE]

Press the F/ALERT], then press F+[UV/MODE], to activate
the "Memory Write" mode.

F+[DIAL]

Press [F/ALERT]; then rotate the [DIAL] knob, to increase
or decrease the frequency at ± 1MHz.

[VOL/MON]+ [DIAL]

Press [VOL/MON]; then rotate the [DIAL] knob, to adjust
volume level.

Tone Calling

Press and hold in the button [ PTT ] and [VOL/MON] to enter
the Tone Calling Mode(1750Hz). The transceiver will send out
a 1750Hz signal. Release the button [VOL/MON] to exit.

Restore to Default Factory Setting

Press and hold the key [ ON/OFF ] + [ F/ALERT ] , then Power
ON, the transceiver will restore to the default factory settings.
Factory Default Setting are: 400.000MHz, No CTCSS/DCS,
Low Output power, Battery Save, Volume Level 5, SQ 5, Key
Tone ON, other settings are OFF.
2 June 20, 2012