Page 3
110 - 120 V 230 V WP 80 SET WSP 80 SET WTP 90 SET T0052918199 T0053312599 T0052922399 WP 120 SET WSP 150 SET WP 200 SET T0052919499 T0052918999 T0052920099 WMRT SET WMRP SET T0051317399N T0052919099N...
Page 13
Please adhere to the operating instructions of the putting the control unit into operation and observe the connected devices. safety precautions specified therein. Only connect WELLER tools. • Safety information If the device is faulty, active electrical conductors may be bare or the PE conductor may not be functional.
Page 14
Check all connected cables and hoses on a regular basis. If Before using the unit / tool, safety devices must be carefully power tools are damaged, they must be immediately checked to make sure that they are functioning properly and removed from use. in the manner intended. Check that moving parts are func- tioning properly and are not sticking, and whether parts are Repairs must always be referred to a Weller-trained damaged. All parts must be correctly fitted and must satisfy specialist. all the requirements necessary to guarantee troublefree operation of the unit. Use original replacement parts only. Use the correct tool. Use only accessories or auxiliary de-...
Page 15
Overload cut-out (150 W) DIN EN 55014-1: 2012-05 DIN EN 55014-2: 2009-06 To avoid overloading a WT 2M station the power is limited to DIN EN 61000-3-2: 2015-03 150 W (see matrix 10). With a required tool performance of DIN EN 61000-3-3: 2014-03...
Need help?
Do you have a question about the WT 2M and is the answer not in the manual?
Questions and answers