Advertisement
4
Mode Selection Instructions
The gimbal can be control
pitching and roll by
connectting to RC receiver.
5
Firmware Upgrade
Adapter
(Down)
6
Initialize The Gimbal
MiNi 2D Gimbal Initialization Instructions:
Keep the gimbal motionless, then power on, keep the gimbal steady and it will initialize automatically.
Once complete the camera will be level with the horizon in pitch and roll angles and it will be in Heading Follow Mode.
In addition to initial power on,the Gimbal needs to be initialized whenever the following situations appear:
1. After power on, the angle of pitch is not level with the horizon line.
2. After power on, the angle of roll is not parallel with the horizon line.
3. When the gimbal is in heading lock, the angle of heading moves frequently (heading is not stationary)
7
Diagram
53.4 mm
91mm
Specification
Items
Working Voltage
Static Attitude Tracking Accuracy
Motion Attitude Tracking Accuracy
Overload Current Protection
Pitch Angle
Roll Angle
Pitching Angle Control Rate
Weight
If any comments or suggestions please do not hesitate to e-mail us directly: service@feiyu-tech.com
Feiyu Tech reserves the right to amend this manual and the terms and conditions of use the gimbal at any time.
MiNi 2D 2-Axis Brushless Gimbal For Aircraft
Suitable For Gopro4 / Gopro3+ / Gopro3 or the cameras with the similar size
Micro USB
USB Cable
Gimbal Connection To PC Diagram
77.8 mm
Min
7.0V
0.01
0.1
-90°（Down）
-45°
The angle of the roll
depends on the position
of the joystick on the
remote control.
Attention:
!
!
computer is done by the
The Gimbal supports firmware upgrade: You can download the
upgrade software and the latest firmware from www.feiyu-tech.com
Standard
Max
8.4V
17.0V
0.02
0.05
0.2
0.5
800mA
0°（Horizontal）
+45°（Up）
0°（Horizontal）
+45°
30°/Sec
110g
Please visit the official website of Feiyu Tech to get related information : www.feiyu-tech.com
The angle of the pitching
depends on the position
of the joystick on the
remote control.
Make sure that the connection to the
USB Connector !
USB Connector
Remarks
Gimbal in static mode
Motor overload<2G
Without camera
Manual Version 3.0
P C
Advertisement
