Flex-a-Lite 130 Installation Instructions

Installation Instructions

Model 130 - Single fan w/ thermo-
Pusher
Model 140 - Single fan w/o ther-
Pusher
Through Core Mounting Instructions
(SEE DIAGRAM "A")
1.Position the electric fan against the front of the radiator,
and mark location of the holes on radiator.(Some appli-
cations may have A/C condensers and/or tranny coolers
on the front of the radiator. Additional adjustments or
modifications may be necessary for installation)
2. Holding fan in position, rotate fan blades to make sure
they are free of obstructions.
3. With a small Phillips screwdriver pass through the
marked holes, carefully spread the fins to allow easy
passage for the nylon bolts (4 for the single fan unit, 6 for
the double fan unit). Pass the bolts through the shroud
holes then twist the bolts through the radiator.
sure to pass through the motor lead connectors when insert-
ing the bolt through the top middle hole of the double unit.
See expanded view on diagram B.
4. Slide the rubber washer, then the steel washer onto the nylon bolt
and finger tighten wing nuts until snug.
5. Once again, rotate fan blades to insure that they are free of obstruction.
OR
Radiator Support Channel Or Frame Installation
(SEE DIAGRAM "B")
1. Attach frame mounting brackets to fan using
nylon bolts, cut them to 1", using wing nuts to
secure.
Note: Be sure to pass through the motor
lead connectors when inserting the bolt through
the top middle hole of the double unit. See ex-
panded view on diagram B.
2. Position fan to desired location, mark holes on
radiator channels or frame.
3. Rotate fan blades to insure that they are free
of obstruction.
4. On the marked hole locations drill 13/64"
holes.
5. Secure the fan to radiator using the provided
1/4" x 1" self tapping screws.
6. Once again, rotate fan blades to insure that
they are free of obstruction.
static control &
A/C relay
mostatic control &
A/C relay
Page 1 of 6
Model 230 - Dual fan w/ thermo-
Pusher
Model 240 - Dual fan w/o ther-
Pusher
Wing Nut
Steel Washer
Note: Be
Black Nylon
Clamps
Motor Leads
(See circled areas for location of
installed clamp. Wire holders
shown in inset.)
static control & A/C
relay
mostatic control &
A/C relay
Diagram A
Rubber Disk Spacer
Diagram B
Self Tapping
Screw
Nylon Bolt
Frame
Mounting
Brackets
Nylon Bolt
(cut to 1")