Important Notices
• It is recommended that child safety seats not be used longer than 10 years
after the date of purchase. The product properties may deteriorate due to
ageing of the plastic and/or sunlight, without this being visibly apparent.
• The manufacturer has taken into consideration the fact that car seats may
cause indentations in the car upholstery. This is unavoidable, however, due to
the prescribed safety standards, and because the car seat must be installed
tightly in order to protect your child, the manufacturer is not liable for any
damage that may occur to the car upholstery as a result of this.
• The seat must always be secured with a seat belt or ISOFIX points even when
not in use. An unsecured seat may injure other passengers in the car in the
event of an emergency stop.
• The Child Safety Seat may be used on either the front or the back seat.
However, we recommend that it is fitted on the back seat.
• Always use the seat, even on short journeys, as this is when most accidents
occur.
• Prior to purchase, check to make sure the seat fits properly in your car, consult
the assistant where you are purchasing your Child Safety Seat.
• Tell your child that he/she should never play with the belt buckle.
• The moving parts of the Child Safety Seat should not be lubricated in any way.
• The safety of the seat can only be guaranteed by the manufacturer if it is used
by the original owner.
• We strongly advise that you never use a second-hand product, as you can
never be sure what has happened to it.
• The belt pads are important for the safety of your child, therefore use them at
all times.
• DO NOT use any load bearing contact points other then those described in the
instruction manual and marked on the child restraint i.e. where the vehicle seat
belt touches the child restraint. If in doubt, please contact the manufacturer.
• NOTE: The adult seat belt buckle should be below the highest load bearing
point of the child safety seat. If in doubt, please contact the manufacturer.
• The
Child Safety Seat
has been approved according to the strictest European
safety standards (ECE R44/04) and is suitable for Group 0 (Birth-10kg) and
Group 1 (9-18kg), Group 2 (15-25kg) & Group 3 (22-36kg).
• WARNING: Do not use the
Child Safety Seat forward facing before your child
is
9kg. It is recommended to use the
Child Safety Seat rearward facing up to
13kg.
•
The mass group and the ISOFIX size class for which this device is intended is
: Group 0/1 (Birth to 18kg); D.
4
Need help?
Do you have a question about the Unify and is the answer not in the manual?