Contents Introduction Important Notices 3 - 4 Restraint Features Use of the Child Restraint in the Vehicle Shoulder Strap Height Adjusting the Height of the Headrest / Harness Adjusting the Recline Position Using the Buckle & Harness System Install Rearward Facing - Group 0+/1 (Birth to 18kg) Seat Belt Install Install Rearward Facing - Group 0+/1 (Birth to 18kg) ISOFIX Install Install Forward Facing - Group 1 (9 to 18kg) Seat Belt Install Install Forward Facing - Group 1/2 (9 to 25kg) Seat Belt, ISOFIX &...
Introduction Dear parents Congratulations on the purchase of your Child Safety Seat. Safety, comfort and user-friendliness have at all times played an important role in the development of the Child Safety Seats. This product meets the most stringent safety regulations and has passed the most stringent compulsary safety testing required by law.
Important Notices • WARNING: Read this instruction manual carefully. Study the illustrations in this instruction manual before use, and, when installing the car seat. The Child Safety Seat is a safety product and is only safe when used according to the instructions.
Important Notices • It is recommended that child safety seats not be used longer than 10 years after the date of purchase. The product properties may deteriorate due to ageing of the plastic and/or sunlight, without this being visibly apparent. •...
Use of the Child Restraint in the Vehicle IMPORTANT: The child seat MUST be installed using a 3-Point Seat Belt. A 2-Point seat belt may not be used. Please observe the regulations applicable to your particular country. The safety belt must be approved to ECE R 16 or a comparable standard . You can use your child car seat as follows: Use in vehicle: Rearward facing child seat...
Adjusting the Height of the Headrest / Harness Adjust the height of the Headrest by pulling the Headrest Handle then move the headrest up or down to suit your childs’ height. The harness straps move while adjusting the headrest. Adjust the Shoulder Straps to the correct height for your child. Rearward Facing Install: The Shoulder Straps must be inline or just below your childs’...
Using the Buckle & Harness System 1 - Loosen the harness by pressing the Harness Adjuster Buckle under the cover located at the front of the seat, then pull the harness straps forward. Do not pull on the belt pads as they will not move. 2 - Unfasten the harness buckle by pressing the red button and remove the tongues.
Install Rearward Facing - Group 0+/1 (Birth to 18kg) Seat Belt Install WARNING: Never use the child seat rearward facing on a vehicle seat equipped with a front airbag. For Group 0+/1 (Rearward Facing Install), the child seat must only be used in the most reclined position, Position 4.
Install Rearward Facing - Group 0+/1 (Birth to 18kg) ISOFIX Install WARNING: Never use the child seat rearward facing on a vehicle seat equipped with a front airbag. For Group 0+/1 (Rearward Facing Install), the child seat must only be used in the most reclined position, Position 4.
Install Forward Facing - Group 1 (9 to 18kg) Seat Belt Install WARNING: Do not use forward facing before your child’s weight exceeds 9kg. 1 - Adjust the child seat to recline position 1,2 or 3 (See page 7). 2 - Place the child seat in a forward facing position in your vehicle (Fig.1). 3 - Pull the vehicle seat belt out as far as possible (Fig.2) and thread the tongue of the vehicle seat belt through the gap at the back of the child seat and clip it into the buckle (Fig.3).
Install Forward Facing - Group 1/2 (9 to 25kg) I-Fix, Seat Belt & Top Tether The child seat can be used forward facing with the Internal Harness up to 25kg when installed with the Vehicle Seat Belt, I-Fix connector and Top Tether.
Install Forward Facing - Group 2/3 (15 to 36kg) Booster Mode The child seat can be installed with or without the Isofix Connectors & Top Tether Strap. For group 2/3 the Isofix Connectors and Top Tether have been designed to improve stability. It is possible to use without this option. 1 - Ensure that the child seat’s 5-point harness is removed correctly (See page 14).
Removing the 5-Point Harness 1 - Loosen the harness by pressing the adjuster buckle located at the front of the seat, then pull the harness straps forward (See page 8). 2 - At the back of the seat, seperate the shoulder straps from the Metal Yoke (Fig.1&2).
Removing the Cover 1 - First, remove the harness system from the child seat (See page 14). 2 - Remove the cover from the shell. Washing Instructions The cover and belt pads are easily removable and can be washed by hand at a maximum temperature of 30 C.
Care & Maintenance Care for the harness buckle It is vital for the safety of your child that the harness buckle works correctly. Malfunctions of the harness buckle are usually caused by accumulations of dirt or foreign bodies. Malfunctions are as follows: •...
Warranty • The warranty period starts from the date of purchase and is valid for a period of 12 months. • The warranty applies to material and manufacturing defects only. • The date of purchase can only be determined with an original sales receipt. •...
Notices Notice 1. This is a “Universal” child restraint system. It is approved to Regulation No.44,04 series of amendments, for general use in vehicles and it will fit most, but not all, car seats. 2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accepting a “Universal”...
Installation Methods Group Weight Recline Position Installation Approx. Age Rearward Facing Birth to (Seat Belt Birth to 4 Years 0+ / 1 18kg Seat Belt & ISOFIX) Recline Position 4 Forward Facing 1 Year to (Seat Belt 9 to 18kg 4 Years Seat Belt &...