Advertisement
INSTALLATION
After unpacking the hob, make sure that it has not been damaged during transport. In the event of problems, contact the
dealer or your nearest After-sales Service.
PREPARING THE CABINET FOR FITTING
-
Install a separator panel
WARNING
under the hob.
-
The lower part of the
product must not be
accessible after
installation.
-
In case of installation of
an undertop oven, do not
interpose the separator
panel.
•
The distance between the underside of the appliance and the separator panel must respect the dimensions given in
the figure.
•
For correct operation of the product, do not obstruct the minimum opening between the worktop and the top of the
cabinet (min.5 mm).
•
Do all cabinet cutting work before fitting the hob, and carefully remove any shavings or sawdust.
•
In case of installation of an undertop oven, make sure the oven has a cooling system.
•
Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into
contact with steam or moisture which could damage them.
•
This product can be embedded in a worktop 30 to 40 mm thick.
•
Before installation, make sure that:
-
the outer surfaces of the furniture or appliances adjacent to the hob are heat resistant according to local regulations;
-
this appliance is not connected to a fume exhaust device. It shall be installed in accordance with current installation
regulations. Particular attention shall be given to the relevant requirements regarding ventilation.
ELECTRICAL CONNECTION
This operation must be performed by a qualified technician.
WARNING
•
The electrical connections must comply
WARNING
with local regulations.
•
The earthing of this appliance is
compulsory by law.
•
Do not use an extension cord.
IMPORTANT: the data relevant to the voltage and power absorption are indicated on the rating plate.
ASSEMBLY
After having cleaned the perimeter surface,
apply the supplied gasket to the hob as shown
in the figure.
Position the hob in the worktop opening made respecting the dimensions indicated in the Instruction.
NOTE: the power supply cable must be long enough to permit its upward extraction.
To secure the hob, use the brackets provided with it. Fit the brackets into the relevant bores and fasten them by means of
their screws in accordance with the thickness of the worktop (see the following figures).
min 20 mm
min 5 mm
DIMENSIONS AND DISTANCES TO BE MANTAINED (mm)
AFTER-SALES SERVICE
POWER SUPPLY: 220-240 V ~ 50/60 Hz
Before calling the After-Sales Service, make sure you can give the following
information:
-
type of fault or problem;
-
exact model (written on the label affixed to the instruction/warranty);
-
service number that follows the word SERVICE on the rating plate under the
hob and on the label affixed to instruction/warranty;
-
your complete address and phone number.
If any repairs are required, please contact an authorised After-Sales Service, as
indicated in the warranty.
Top 30 mm
Top 40 mm
Advertisement
