INSTRUCTIONS FOR USE PRODUCT DESCRIPTION AND SYMBOLS USING THE BURNERS PRACTICAL ADVICE ON USING THE HOB POSITIONING THE PAN SUPPORTS AND WOK SUPPORT HOOD AND CABINETRY CLEARANCES (MM) INJECTOR TABLE WARNINGS AND SUGGESTIONS SAFEGUARDING THE ENVIRONMENT INSTALLATION (FLUSH AND TRADITIONAL FITTING) GAS CONNECTION ELECTRICAL CONNECTION FIXING THE HOB TO THE WORK TOP.
PRACTICAL ADVICE ON USING THE HOB Read the instructions to get the best out of your hob. • Use pans with a similar diameter to the burner (see the table on this page). • Use flat bottomed pans except with the wok support.
HOOD AND CABINETRY CLEARANCES (MM) If a hood is to be installed above the hob, refer to the hood installation instructions to ensure the correct height above the hob. INJECTOR TABLE CATEGORY: II2H3+ Type of gas Type of Injector used burner label NATURAL...
WARNINGS AND SUGGESTIONS To get the most out of your hob, please read the instructions carefully and keep them for future consultation. • These instructions are only valid in the countries whose destination symbol is shown on the serial number plate on the hob. •...
SAFEGUARDING THE ENVIRONMENT Packing The packing material is 100% recyclable and is labelled with the recycling symbol dispose of all packing responsibly and carefully. Product This appliance is marked according to the European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this product is disposed of correctly, you will help prevent potentially negative consequences for the environment and human health.
150 mm to the underneath of the work surface. • This hob is designed to operate perfectly with any oven in the Whirlpool range. The Manufacturer declines all responsibility should another make of oven be installed.
ELECTRICAL CONNECTION The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. plate. • The appliance must be earthed. •...
Page 9
FIXING THE HOB TO THE WORK TOP. FLUSH FITTED MODEL Important: The following procedure must be carried out by competent technical personnel only. The hob can be installed on, or into different types of materials, such as masonry, metal, wood and heat resistant laminate coated wood (90°C).
ADAPTION TO A DIFFERENT TYPE OF GAS SUPPLY If you are using a different kind of gas from the one indicated on the serial no. plate and the orange label on the back of the hob, you must replace the injectors;...
FITTING THE WOK BURNER To fit the double crown wok burner: Insert in the following order: 1. burner ring (A); 2. decorative covering ring (B); 3. external burner cap (C); 4. internal burner cap (D). Note: make sure that: 1. the locating pin for the burner ring (A) is inserted correctly in the slot on the burner unit.
GENERAL CLEANING & MAINTENANCE Always disconnect the hob from the electrical power supply and wait until it cools before cleaning and/or doing maintenance work. In order to keep your hob in good condition, you must keep it clean, removing any food residue each time you use it. Cleaning the hob surface: •...
TROUBLESHOOTING GUIDE If the hob is not working properly, work through this guide before contacting our Customer Care Centre. The burner does not ignite, or the flame is unsteady? Check that: 1. the gas, or electricity supply has not been interrupted and that the control knob is turned fully on.