Metri-Pack; Removal Procedure; Installation Procedure; Special Tools - Isuzu 4HL1 Workshop Manual

Removal Procedure

Some connectors use pins called Metri-Pack Series
150. These may be used at the engine coolant
temperature (ECT) sensor.
1. Slide the seal (1) back on the wire.
2. Insert the tool 5-8840-0632-0 or equivalent (3) in
order to release the pin locking tang (2).
3
3. Push the wire and the pin out through the
connector. IF you reuse the pin, reshape the
locking tang.

Special Tools

Illustration
2
LNW21ASH005601
Tool No.
Tool name
5-8840-0632-0
Terminal Remover

Metri-Pack

Installation Procedure

Metri-Pack pins are also referred to as "pull-to-seat"
pins.
1. In order to install a pin onto a wire, the wire must
be inserted through the seal (2) and through the
connector (3).
2. The pin (1) is then crimped onto the wire.
1
3. Then, the pin is pulled back into the connector to
seat it in place.
Engine Control System 1A-263
1
2
3
LNW21ASH005701