Table of Contents
Advertisement
1A-102 Engine Control System
Step
Reset the accumulated number of startups.
1.
Engine "OFF", starter switch "ON".
2.
Using Tech 2, reset the accumulated
number of startups.
4
3.
Start the engine.
4.
Engine "OFF", starter switch "OFF".
Is the action complete?
Review the DTC.
1.
Using Tech 2, clear the DTC.
5
2.
Perform test run and review the DTC.
Is DTC18 detected?
1.
Replace the VIM.
IMPORTANT:
If necessary (for the vehicle equipped with
6
idle stop function), input the number of
startups to the replacing VIM.
Is the action complete?
Check DTC18 will not be set again.
1.
Using Tech 2, clear the DTC.
7
2.
Perform test run and review the DTC.
Is DTC18 detected?
Action
Value(s)
Yes
—
Go to Step 7
—
Go to Step 6
—
Verify repair and
go to Step 7
—
Refer to
Diagnostic Aids
and go to Step 2
No
—
Refer to
Diagnostic Aids
—
Repair is
complete
Hide quick links:
Advertisement
Table of Contents
