Isuzu 4HL1 Workshop Manual page 130

1A-128 Engine Control System
Step
Check the VIM ground circuit for open wiring.
1. Starter switch "OFF".
2. Disconnect the VIM.
4
3. Measure the resistance between VIM
connector pin and ground (e.g., frame or
body)
Was the resistance within range?
Repair or replace the faulty harness.
5
Is the action complete?
1. Replace the VIM.
IMPORTANT:
If necessary (for the vehicle equipped with
6
idle stop function), input the number of
startups to the replacing VIM.
Is the action complete?
Check DTC33 will not be set again.
1. Using Tech 2, clear the DTC.
7
2. Perform test run and review the DTC.
Is DTC33 detected?
Action Value(s)
Pins 39/52/
60/66/73-
ground: 0 Ω
Go to Step 6
Verify repair and
—
go to Step 6
—
Verify repair and
go to Step 7
—
Refer to
Diagnostic Aids
and go to Step 1
Yes No
Go to Step 5
Repair is
complete
—
—