Tennant S30 XP Instruction Bulletin

INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9004325
SYNOPSIS:
This kit contains the parts needed to replace the instrument panel label on S30 XP and S30 X4
machines.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 1 hour)
PREPARATION:
1. Park machine on a clean level surface, turn off
machine, remove key, and set parking brake.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, set parking
brake, turn off machine, and remove key.
2. Disconnect the negative terminal from the
battery.
WARNING: Always disconnect battery
cables from machine before working on
electrical components.
3. Remove the hardware holding the panel
assembly to the dash. Discard the hardware.
Refer to Fig. 1.
FIG. 1
IB 340883 (02- -2008)
4. Carefully lift the panel assembly from the
dash and disconnect the main wire harness
from the panel assembly. Refer to Fig. 2.
FIG. 2
5. Set the panel assembly face down on a clean
flat surface.
No. 340883
Machine: S30 XP / X4
Published: 02- -2008
Rev. 00
1