DURKOPP ADLER M-TYPE PREMIUM COMMANDER User Training Manual page 33

Exercise: Sewing in Manual Mode, other parameters
Pre-setting in Manual Mode
• modify the base parameters:
• stitch length 5.0 mm
• needle thread tension 25%
• sewing foot pressure 5
• sewing foot stroke 1,5 mm
• modify the other parameters
• Thread Trim active On
• Start bartack active (On)
• Number of backward stitches (3 points)
• Number of forward stitches (3 points)
• St.Len.Def – Default stitch length active (On)
• End bartack active (On)
• Number of backward stitches (4 points)
• Number of forward stitches (4 points)
• St.Len.Def – Default stitch length inactive (Off)
– backward stitch length (2.5 mm)
– forward stitch lengths (2.5 mm)
• Gap (edge guide): 10 mm
During sewing process
• start sewing
(automatic start backtack)
• activate/deactivate the auxiliary values:
• activate 2 nd stitch length
• activate 2 nd foot stroke
• activate 2 nd thread tension
• deactivate the secondary values
• interrupt the sewing process (pedal)
• lift your foot from pedal
• continue sewing process / resume
• stop sewing, end of seam (pedal -2)
(automatic end backtack)
32