Korg Nu:tekt OD-KIT Owner's Manual page 11

11. Solder the 3-terminal regulator (1).
Be sure to mount the part in the correct direction.
12. Solder the DC jack (44).
Solder the DC jack carefully so that it is flush with the circuit board
without being slanted.
13. Solder the volume controls (48, 49, 51).
Turn the circuit board upside-down to mount and solder the volume
controls.
Solder the volume controls carefully so that they are flush with the
circuit board without being slanted.
Tip: It may be difficult to solder the volume controls if you have installed
the phone jacks first.
14. Turn the circuit board over once more, and then install the phone
jacks (45).
The spacers on the circuit board are necessary to correctly align the
angles of the jacks and the housing, so do not remove them. Attach the
jacks so that they are flush with the spacer and circuit board.
- 11 -
Phone jack
spacer
circuit board
Upper case