THUNDER TIGER Titan Raptor 50 Size 3D Heli Assembly & Maintenance Manual page 6

1 Fuel Tank Assembly
Note: After assembly, check to make sure the Fuel Tank
clunk can move from top to bottom without touching the
back of tank. Also, a fuel filter (available from any hobby
shop, TTR1165C) should be placed between the fuel tank
and the carburetor.
To Header Tank
Connect the fuel tube to
header tank
(See Page 17 Step.17)
TTR1165C FUEL FILTER
Not included in the kit
(1) BK0605 Fuel Tank .....................1
(2) BK0062 Fuel Tank Grommet......1
(3) BK0463 Fuel Tank Nipple ..........1
(4) BE1867 Clunk.............................1
(5) CB0363-1 Silicone Fuel Tube.....1
(6) BB0362-2 Silicone Fuel Tube.....2
2 Clutch Bell Assembly
(1) HMV1680 Bearing (d8xD16xW5)......1
(2) HMV1360ZZY Bearing (d6xD13xW5)...1
(3) BK0838 Clutch Bell...........................1
(4) BK0624 Drive Gear(Pinion 10T).......1
(5) BK0887 Clutch Liner.........................1
(6)
(6)
To Muffler
(1)
(2)
(5)
5
It might be necessary to inspect and replace the silicone
tube inside the tank every month to ensure the fuel
consumption is smooth.
(3 )
(1)
(4)
Add Loctite and tighten
(3)
The liner comes glued in the
clutch bell already.
(2 )
(5 )
(4 )
The fuel tank comes
assembled allready.