Maintenance; Troubleshooting; Battery Removal - Black & Decker 90544571 Instruction Manual

90544571 PD400 clutch sc
• DO NOT CLICK THE TRIGGER OF A STALLED TOOL OFF AND ON IN AN ATTEMPT
TO START IT. DAMAGE TO THE TOOL CAN RESULT. To remove, twist the bit back
and forth and straight out.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through last
part of hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce
jamming.
• Make sure switch turns tool on and off.
WARNING: It is important to support work properly and to hold the tool firmly to prevent
loss of control which could cause personal injury.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
The use of any accessory not recommended for use with this tool could be
hazardous.
Problem
• Tool will not charge.
• Tool will not drill.
• Screws stripping
• Screws not fully seated.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.

BATTERY REMOVAL

Before attempting to disassemble this tool, turn it on and run it in either direction until it
stops to ensure a complete discharge of the batteries. Using a phillips screwdriver,
remove the screws from the product housing and take the two body halves apart. Lift the
batteries out and pull off the terminal clips. See "Service Information" for battery
replacement and RBRC for battery recycling.
5/22/09 7:46 AM Page 9

Troubleshooting

Possible Cause
• Charger not plugged into
a working outlet.
• Surrounding air temperature
too hot or too cold.
• Clutch collar in wrong
position.
• Clutch collar setting
too high.
• Clutch collar setting
too low.
9
Possible Solution
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Check current at
receptacle by plugging in
a lamp or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when you turn
out the lights.
• Move charger and tool
to a surrounding air
temperature of above 40
degree F (4,5°C) or below
105 degree F (+40,5°C).
• Move collar position to
drill bit icon.
• Move collar position to
a lower setting.
• Move collar position to
a higher setting.