Graco FinishPro CompPack Series Repair Manual page 2

Setup
CompPack Installation
For references (1) - (99), see Parts, manual 313406. For
reference numbers(101) - (199) see Parts, page 7.
1. Turn off and unplug sprayer.
2. Loosen four screws (18), remove hose wrap (35), fil
ter retainer (17), pre-filter (20) and main filter (21).
21
20
17
18
3. Install CompPack (A) on sprayer.
21
ti12857a
2
35
ti13061a
A
35
20
17
105
4. Install main filter (21), pre-filter (20), filter retainer (17)
and hose wrap (35) with four screws (105).
Spray Gun with Optional Remote Cup
The optional remote cup comes with two hoses.
1. Connect the short hoses to their matching long
sprayer hoses.
2. Convert spray gun from siphon cup operation to
remote cup operation. See Convert Gun from
Siphon Cup to Optional Remote Cup.
3. Connect air hose (A) to sprayer.
Hand tighten. Do not connect
whip hose direct to sprayer.
Connect whip hose to gun end of
hose only.
4. Connect air hose (A) from
sprayer to inlet fitting of spray gun.
5. Connect air hose (B) between
CompPack outlet and remote cup
air inlet.
Setup
C
A
B
ti12798a
ti13082a
ti12797a
313440E