Festool CLEANTEX Series Original Operating Manual/Spare Parts List page 18

CLEANTEX CTL/ CTL AC
GB
9 Service and maintenance
WARNING
Risk of injury, electric shock
X
Always disconnect the mains plug from the
socket before performing maintenance
work on the machine!
X
All maintenance and repair work which re-
quires the motor housing to be opened
must only be carried out by an authorised
service workshop.
Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop, unless otherwise indi-
cated in the operating manual.
Observe the following instructions:
– A dust test must be performed at least
once a year by the manufacturer or an in-
structed person. This test may include
checks to determine whether the filter is
damaged, the machine is sealed properly
and the monitoring features are function-
ing correctly.
– During maintenance and repair work, all
components that cannot be cleaned satis-
factorily must be replaced. The old compo-
nents must be sealed in impermeable
plastic bags prior to disposal in compliance
with applicable regulations for this type of
waste.
9.1 Changing the filter element
NOTE
Motor damage
X
Never operate the extractor without a fil-
ter element fitted as the motor may be-
come damaged.
X Open the locking clips
the top section of the machine[2-1].
X
Turn the top section of the machine so
that the main filter is facing upwards
(Fig.[9]).
X
Fold over the lever
retainer. [9-2]
X
Remove the used main filter and replace
[9-1] with a new one.
X Dispose of the used filter in accordance
with statutory regulations.
18
[2-2] and remove
[9-3] and remove the
X
Insert the retainer
lever [9-3] until it engages.
X Replace the top section
the locking clips [2-2].
9.2 Emptying the dust container
The dust container
once the top section has been removed.
X
After extracting fluids, clean the fill level
sensors [10-1] regularly with a soft cloth
and inspect for damage.
10 Accessories
Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers for the accessories and
filters can be found in the Festool catalogue
or on the Internet at "www.festool.com".
10.1 Modules
The following modules for upgrading the mo-
bile dust extractor are available in the acces-
sories programme. Modules must be fitted to
the module slot [1-2]
vice workshop:
– Compressed air module,
– Socket module with permanent power sup-
ply,
– Socket module with automatic switch-on
unit (not suitable for GB 110 V version),
– Energy box module (EAA) for using the au-
tomatic switch-on unit on the EAA.
You can find more detailed information on
the modules at "www.festool.com".
11 Disposal
Do not throw the tool in your household
waste!! Dispose of machines, accessories
and packaging at an environmentally re-
sponsible recycling centre. Observe the valid
national regulations.
[9-2] and fold over the
[2-1] and close
[2-3] can be emptied
by an authorised ser-