Installing The Electrode Clip; Installing The Ip54 Cover Caps; Integrated Stand For Table Top Use - OHAUS STARTER 300D Instruction Manual

EN-6
2.3

Installing the electrode clip

The electrode clip is an electrode holder that can be placed next to the display on either side of
the housing.
ƒ Attach the clip by inserting the tabs into the recess.
ƒ Slide the clip forward to lock in position. Slide the shaft of the sensor into the clip from above.
2.4

Installing the IP54 cover caps

Use the small plastic tool as shown:
2.5

Integrated stand for table top use

Starter 300D has an integrated table stand as shown, which can be pushed out to use the meter on
a lab bench or desk. To close the stand, push the middle edge of the stand toward the meter.
STARTER 300D Portable DO Meter