Advertisement
6100 SERIES PUSH/PULL LATCH - DOOR PREP
BEVEL EDGE DOOR
UNIVERSAL OR
SQUARE EDGE DOOR
BACKSET
2-3/4"
3-3/4"
5"
7"
1" DIA. HOLE
5/32"
(THRU ALL
SUPPORTS)
2-1/4"
13/16"
C L
13/16"
LOCK
&
STRIKE
#8-32
TAPPED HOLE
(2 PLACES)
1-1/8"
METAL DOOR
(VERTICAL OR HORIZONTAL MOUNTING SHOWN)
DOOR PREP INFORMATION:
1. BACKSET DIMENSION FROM LOW EDGE OF BEVEL.
2. CENTER PUNCH ALL HOLES.
3. DRILL HOLES (FOR HOLLOW METAL DOORS,
DO NOT DRILL THRU. CENTER PUNCH & DRILL
HOLES FROM BOTH SIDES OF DOOR).
4. REINFORCEMENT MUST BE APPLIED ON METAL
DOORS AT THE SCREW LOCATIONS.
5. REINFORCEMENT TO BE SUPPLIED BY DOOR
MANUFACTURER. THE HANDLE ASSYS MUST BE
SUPPORTED. THE LATCH BOLT UNIT MUST BE
SUPPORTED AND CENTERED WITHIN 1/16" OF
THE CENTERLINE AT THE BACK END.
EDGE GUARD NOTE:
WHEN PREPPING THE
DOOR FOR THE BACKSET,
DETERMINE IF THE DOOR
WILL RECEIVE AN EDGE
GUARD. IF SO, THE EDGE
GUARD SHOULD BE
INSTALLED FIRST AND
THEN THE PREP FOR THE
LATCH BACKSET SHOULD
BE MEASURED FROM THE
OUTSIDE EDGE OF THE
EDGE GUARD.
1" DIA. HOLE REQUIRED, 2 PLACES
"HOLE" IN REINFORCEMENT
BACKSET
2-1/8" DIA.
HOLE THRU
REINFORCEMENT BY
DOOR MFG.
O
www.abhmfg.com
R
E-mail: abhinfo@abhmfg.com
Architectural Builders Hardware Mfg., Inc.
1222 Ardmore Ave., Itasca, IL 60143
630.875.9900; FAX 800.9FAXABH (932.9224)
BEVEL EDGE DOOR
UNIVERSAL OR
SQUARE EDGE DOOR
BACKSET
2-3/4"
3-3/4"
5"
7"
1-1/8" DIA. (MIN)
SEE DEPTH OF
BORE CHART
13/16"
C L
13/16"
LOCK
&
STRIKE
DRILL FOR #8
WOOD SCREW
(2 PLACES)
1-1/8"
(VERTICAL OR HORIZONTAL MOUNTING SHOWN)
ADA
RECOMMENDED
HEIGHT 44" FROM
FINISHED FLOOR
TO CENTER LINE
-OR-
CHECK LOCAL ORDINANCE
FOR PROPER HEIGHT
c 2017 ABH Mfg., Inc.
printed in USA
DOOR LATCH PROVISIONS
DEPTH
OF
BORE
BACKSET
4-3/8"
DEPTH OF BORE
5-3/8"
6-5/8"
2-1/8" DIA.
8-5/8"
HOLE THRU
5/32"
2-1/4"
WOOD DOOR
VERIFY BACKSET
CENTER LINE
PAGE 2 OF 3
REVISED 05-19-17
6100-2-10.DWG
6100
Advertisement
