Makita 7104L Technical Information page 5

R
epair
When removing M14 Screw from the front vice section;
1) Press the end of M4 Screw against table to compress
Compression spring 10.
2) At the same time, push out 4-20 Spring pin in M14 Screw
using Spring pin extractor 4.0 (Makita part No. 1R308).
See Fig. 12.
[7] Adjustment
Note: The following information applies to the products including 16.5mm cutter chain as the standard accessory.
1) Fix an yellow colored Indication plate to Base complete with M4x8 pan head screw as shown in Fig. 13 after aligning
the front edge of the Indication plate with front end of 16.5mm cutter chain.
2) When aligning the center of + Countersunk head screw M6x12 with the bottom of Base complete, drive Stopper pole
into the Base complete by hand in order to adjust the height of Rotor holder at ZERO position on Stopper pole as
shown in Fig. 14. After positioning it, tighten M8 Hex. nut onto the hole of Base complete firmly using Wrench.
Note: Face the gauge of Stopper pole to outside before tihgtening M8 Hex. nut.
3) Align the left end of Scale plate with the left end of the cutter chain by resetting the scale plate on the Base complete.
See Fig. 15.
Fig. 13
Indication plate
Fig. 14
Center of + Countersunk
head screw M6x12
Hex. nut M8
6
Pan head screw M4x8
6
Bottom of Base
complete
Rotor holder
Threads of the
Stopper pole
Stopper pole
Base complete
Fig. 12
Spring pin 4x20
M14 Screw
Slide Indication plate
backward or forward.
Front edge of Indication
plate (yellow)
Gauge of the Stopper
pole
Fig. 15
P 5 / 8
Spring pin extractor 4.0
Plastic hammer
Table
Front end of 16.5mm
cutter chain
"ZERO" mark
Left end of 16.5mm
cutter chain
Scale plate
6
Left end of Scale plate