Flex-a-Lite 316 Instructions

High Volume Adjustable Electric Fan
Part numbers:
# 314 - 14" fan
# 316 - 16" fan
# 318 - 18" fan

Each kit includes

(1) fan, motor & bracket assembly
(4) round aluminum struts
(8) 3/8 - 16 x 1.25" bolts
(4) 3/8 - 16 star nuts
(8) flat washers
(2) "L" brackets
(1) 3/32 allen wrench
(1) nylon bolt kit
(1) instruction sheet
(1) "Caution" label
1. Insert the non-threaded end of the round aluminum struts into the square struts of the electric fan
assembly. Lightly tighten the allen set screw in the square strut, final adjustments may be necessary.
(See diagram A)
2. This unit is designed to push or pull air and can be mounted vertically or horizontally.
IMPORTANT: It is not necessary to flip the fan blade or reverse the polarity to change to push or pull
configurations. Typically puller fans are more efficient at moving air than pusher fans.
To "push" air from the front of the radiator:
Attach the "L" brackets to the ends of the round threaded struts so that the electric fan motor is facing the
radiator. (See diagram B)
Use the bolts and washer supplied to attach the "L" brackets. (See diagram A)
To "pull" air from the back of the radiator:
Attach the "L" brackets to the ends of the round threaded struts so that the electric fan blade is facing the
radiator. (See diagram C)
Use the bolts and washer supplied to attach the "L" brackets. (See diagram A)
Instructions
Flat washer
3/32 Allen
set screw
Fan, motor &
bracket assembly
Frame mounting
slots

Adjustable Fan Assembly

3/8 - 16 x 1.25 bolt
"L" bracket
Round aluminm
strut
Diagram A
3/16" Through core
mounting holes