Installation; Before You Begin; Tools And Parts Needed; Parts Included - Thermador M271 Installation Manual

Installation

Before you Begin

Tools and Parts Needed

Parts Included

27" Appliances

General Information

Power Requirements
Dimensions for 27" Wall-Mounted Units
• Phillips head screwdriver
• Measuring tape
• Drill with bit (1/8")
• Phillips head screws (6)
The outlet must be properly grounded in accordance with all applicable codes.
Single Oven 27"
It is good practice, when oven is in-
stalled at the end of a cabinet run, ad-
jacent to a perpendicular wall or
cabinet door, to allow at least 1/4"
space between the side of the oven
and the wall/door.
For oven support, install 2x4's extend-
ing front to back flush with the bottom
and the side of the opening. The sup-
porting base must be well secured to
the floor/cabinet and level.
Note: The conduit box must be in-
stalled either above or below the unit. If
the conduit box is installed below the
unit, a 2" diameter hole or space is re-
quired between the back wall and the
right rear of the 2x4 supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 210 lbs (95 kg).
5