Rebuilding The Raid - Asus Pro WS 621-64L SAGE Series Manual

4.2.5

Rebuilding the RAID

This option is only for the RAID 1 set.
Rebuilding the RAID with other non-RAID disk
If any of the SATA hard disk drives included in the RAID 1 array failed, the system displays
the status of the RAID volume as "Degraded" during POST. You can rebuild the RAID array
with other installed non-RAID disks.
To rebuild the RAID with other non-RAID disk:
1. During POST, press <Ctrl>+<I> at the prompt to enter the Intel Rapid Storage
Technology option ROM utility.
2. If there is a non-RAID SATA Hard Disk available, the utility will prompt you to rebuild
the RAID. Press the up/down arrow keys to select the destination disk then press
<Enter> to start the rebuilding process, or press <ESC> to exit.
"Degraded" volume and disk available for rebuilding detected. Selectign
a disk initiates a rebuild. Rebuild completes in the operating system.
Select the port of destination disk for rebuilding (ESC to exit):
Port
X
Select a destination disk with the same size as the original hard disk.
4-8
[ DEGRADED VOLUME DETECTED
Drive Model Serial #
XXXXXXXXXXX XXXXXXXX
[ ]-Previous/Next [ENTER]-Select [ESC]-Exit
]
Size
XXX.GB
Chapter 4: RAID Configurations