Audio Physic VIRGO III Manual page 15

8. Place the plastic washers included in the delivery onto the bore holes of the stands from above and insert
the provided flange bolts into the holes. Tighten the flange bolts firmly. The bolts need about seven turns
for optimum grip.
9. Now turn over the loudspeakers so that the metal feet are in stable contact with the floor. Two people should
also carry out this step where possible. Make sure that you do not hurt yourself on the tips of the spikes.
10. Place the loudspeakers in their intended positions and finely adjust the spikes so that the
loudspeakers do not wobble. If you do not place the loudspeakers in a secure and stable
position and they therefore wobble, this will have a major effect on the sound. When the
boxes are standing level and upright, you have set them up perfectly. The enclosed spirit
level will help you to finely adjust the loudspeakers (they are level when the bubble remains
in the inner circle). Use the lock nuts to again tighten the spikes. Roughly hand-tightening
the nuts is sufficient.
You can now start to optimally align your new VIRGO III to the listening position. You can find tips
regarding this process in the following chapter on "Setup" and can access particularly detailed information on the
AUDIO PHYSIC website.
15