1. Manuals
  2. Brands
  3. RadonAway Manuals
  4. Fan
  5. GP500
  6. Installation instruction

RadonAway GP500 Installation Instruction

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Page 1 of 8
IN006 Rev G

Advertisement

Table of Contents
loading

Related Manuals for RadonAway GP500

Summary of Contents for RadonAway GP500

  • Page 1 Page 1 of 8 IN006 Rev G...
  • Page 2 RadonAway Ward Hill, MA. GP500 Fan Installation Instructions Please Read and Save These Instructions. DO NOT CONNECT POWER SUPPLY UNTIL FAN IS COMPLETELY INSTALLED. MAKE SURE ELECTRICAL SERVICE TO FAN IS LOCKED IN "OFF" POSITION. DISCONNECT POWER BEFORE SERVICING FAN.

  • Page 3: System Design Considerations

    GP500. The lack of cooling air may result in the GP500 cycling on and off as the internal temperature rises above the thermal cutoff and falls upon shutoff.

  • Page 4: Condensation & Drainage

    U-Tube manometer or a vacuum alarm is recommended as a "System On" Indicator for affirmation of system operation. SLAB COVERAGE The GP500 can provide coverage up to 1000+ sq. ft. per slab penetration. This will, of course, depend on the sub-slab material in any particular installation and the diagnostic results.

  • Page 5: Electrical Wiring

    All wiring must be performed by a qualified and licensed electrician. SPEED CONTROLS The use of electronic speed controls on the GP500 is NOT recommended. INSTALLATION A.C. POWER CONNECTION The GP500 requires an 18 gauge, 3 wire SJ power cord, RadonAway p/n 27003 or equivalent.
  • Page 6 Install the pipe coupling as shown in Figure 6, making certain to avoid sharp bends or kinks in the piping. (TIP: You may connect the pipe coupling to the GP500 before installing the unit through the band joist.) MUFFLER INSTALLATION (Optional) Install the vent muffler assembly in the selected location in the outlet ducting.

  • Page 7: Operation Checks

    Inlet/Outlet: 3" PVC Mounting: Brackets for vertical mount on bandjoist or sidewall. (16" Mounting Centers) Outdoor installations - GP500 mounts flush to wall projecting only 4" with inlet duct passing through the sidewall or band joist. Power cord is on the inside simplifying connection.

  • Page 8: Warranty

    RadonAway will replace any Fan which fails due to defects in materials or workmanship. The Fan must be returned (at owner’s cost) to the RadonAway factory. Any Fan returned to the factory will be discarded unless the Owner provides specific instructions along with the Fan when it is returned regardless of whether or not the fan is actually replaced under this warranty.

Table of Contents