Roughing-In Dimensions; Installation; Preparation; Install Spout Supply Tube - Kohler REVIVAL Series Installation Instructions Manual

ROUGHING-IN DIMENSIONS – CONTINUED
X = Distance from centerline of spout inlet to front of spout
base plus 1/2" (1.3cm).
Y = Distance between valve centerlines may vary
depending on your installation requirements.
* Dimension allows for 1/4" (6mm) handle adjustment
during handle trim installation.
1-5/16" D.
1-1/8" D.
5/8" I.D. (1/2" NOM.)
1-5/16" D.
1-1/8" D.
5/8" I.D. (1/2" NOM.)

2. INSTALLATION

PREPARATION

For installations with 8" (20.3cm) centers using copper
tubing (1/2" nominal, 5/8" O.D.), cut tubing to the lengths
as follows:
2-pieces: 2-7/8" (7.3cm) long
1-piece: 2-3/8" (6cm) long (for finished deck or bath rim
installation only).

INSTALL SPOUT SUPPLY TUBE

Slide brass washer from bottom of spout supply tube over
threads until washer reaches supply tube shoulder.
Insert spout supply tube through mounting hole from top
of deck/bath rim. Ensure flat portion of washer faces
forward. Spout supply tube will be suspended by washer.
Slide plate (oriented with tabs toward deck) and washer
onto spout supply tube from bottom and thread on
mounting nut. Tighten nut.
Secure plate to deck or wooden support with two wood
screws.
NOTE: Leave protective sleeve on spout supply tube un-
til spout installation.
BB
113341-2-
Y
1/2" (1.3cm) MIN. - 2-1/8"
(5.4cm) MAX. DECK
THICKNESS
1-13/16" (4.6cm)
7/8" D.
4-5/8"
5-5/8"
(11.7cm)
(14.3cm)
5/8" O.D. TUBING (1/2" NOM.)
FINISHED DECK- AND BATH-MOUNT ROUGHING-IN
Y
7/8" D.
5/8" O.D. TUBING (1/2" NOM.)
ROUGH DECK PLUS FINISHED DECK (TILE) ROUGHING-IN
Diameter of hole in deck for spout = 1-1/8" (2.9cm) Max.
Diameter of hole in deck for valve = 1-1/2" (3.8cm) Max.
Thin deck/bath rim installations require additional support
under deck/bath rim. Use 1/2" exterior grade plywood.
For installations on a rough (unfinished) deck to be
covered later with tile, the tile thickness must not exceed
1-1/4" (3.2cm).
X
1-1/4" (3.2cm) MAX.
TILE THICKNESS
*1-1/4" (3.2cm)
1/2" (1.3cm) MIN. - 2-1/8" (5.4cm)
MAX. ROUGH DECK THICKNESS
Fig. #2
For non-8" (20.3cm) center installations, adjust tubing
lengths as necessary.
Spout Supply Tube
Supply Tube Shoulder
Wood Screw
2
1/8" (3mm) MIN. - 2-1/8"
(5.4cm) MAX. BATH RIM
THICKNESS
X
Brass Washer
Plate
Wood Screw
Nut
Washer
Fig. #3
Kohler Co., Kohler, WI
X