Autoexec.bat And Config.sys Files; Default Autoexec.bat File - Texas Instruments TravelMate 3000 WinSX User Manual

Guidelines for Installing Applications
5-4 Installing and Using Application Programs

AUTOEXEC.BAT and CONFIG.SYS Files

If your application program requires additions or changes to the TravelMate 3000 winsx's
AuToExEc.BAT and CONFIG.SYS files-as suggested several times in this chapter and
other chapters of this manual-carefully consider the consequences that may result from
changes or deletions to these two files. The factory-installed (default) files are listed and
described in the following two sections.
Please read and understand these two files before you change them. See the MS-DOS
User's Guide and Reference furnished with your TravelMate 3000 WinSX for more
details on constructing these files and their significance.
Note: If you need to restore the default AUTOEXEC.BAT and CONFIG.SYS files to
your hard disk, they are included on the BatteryPro & Productivity Software floppy
furnished with your computer.

Default AUTOEXEC.BAT File

Each line of the AUTOEXEC.BAT file and its purpose are defined in the table following
the file listing.
@ECHO OFF
PROMPT $P$G
PATH=C:\WINDOWS;C:\UTILS;C:\;C:\DOS
SET TEMP=C:\DOS
SET COMSPEC=C:\DOS\COMMAND.COM
SET MFILE=C:\UTILS
REM = To run RPAL, remove the REM from the RPAL line REM
REM RPAL /I
GETSTAT /B
IF ERRORLEVEL -1 COTO BATTERY
COTO DONE
:BATTERY
VERIFY ON
:DONE
MPOWER OFF >NUL
REM
REM = To run LM, remove the REM from the LM line and REM = place a REM in front
of WIN/3.
REM
REM LM
WIN /3