Texas Instruments TravelMate 3000 WinSX User Manual page 168

Error Messages
Fixed disk failure
Fixed disk read failure -
press F1 to retry
boot
Invalid Configuration
Information
-Press Enter to run
Set _Up.
-Press the F1 key to
continue.
Keyboard clock/data
line failure
Turn off the computer, wait
5 seconds, and turn the com-
puter on again, or press the
Ctrl-Alt-Del keys to reboot
the system. If that does not
work, run the DIAG program
to check the hard disk drive
as described in Appendix D,
then contact your Texas
Instruments reseller.
Defective working diskette or
hard disk - Boot the system
again. If that does not work,
replace the floppy. Run the
DIAG program to check
drives as described in Appen-
dix D. If the hard disk drive
is at fault, contact your
Texas Instruments reseller.
Wrong configuration settings
- Check the settings on the
Setup Program menus, par-
ticularly Memory category
selections (Unused must
equal 0) and number of Dis-
kette drives (see Chapter 4 to
run Setup Program).
Defective keyboard or exter-
nal keyboard connector -
Make sure your external key-
board is connected correctly;
if it is, the problem could be
keyboard failure. Contact
your Texas Instruments
reseller.
Troubleshooting E-7