Advertisement
IDS1632 INSTALLER MANUAL
The keypad/s attached to a system as defaulted above will have no ID
and will therefore not communicate with the panel. This is indicated
by all keypad LEDís flashing simultaneously. In order to enroll a
keypad (thereby giving the keypad an ID) press the [#] key of the
keypad you wish to enroll. The enrolled keypad will now indicate the
alarm status. Repeat this process with the remaining keypads where
more than 1 keypad is used. The first keypad enrolled will have an ID
of 1, the second enrolled will have an ID of 2, the third an ID of 3 etc. A
maximum of 8 keypads may be used.
Note : If the keypad zone is to be used, consideration must be given
to the sequence in which keypads are enrolled as this affects
the LED zone designation. The keypad 1 will contain zone
16, keypad 2 will contain zone 15 etc. as per
section 14 in this manual.
If a keypad is replaced in a multi keypad system the new keypad
when enrolled will be assigned the first available slot. I.e. keypad 3 in
a 5 keypad system is replaced due to a fault. When the new keypad
is enrolled it will be allocated a value of 3. If in this case a new keypad
was added to the system (6th keypad), it would be assigned an ID of
6.
1
. 4
D
e
To default the I.D of a keypad(s):
1.
Remove power to the keypad (or the whole panel if easier). Whilst
holding down the [ 1 ]and [ 3 ] keys restore the power to the
keypad.
2.
All the keypad LEDís will flash simultaneously indicating that the
keypad has now been de-registered.
Note : In a multi keypad installation this process only
defaults the individual keypad at which this operation
was performed. Wait for five seconds and then press
the [#] hash key to allocate a new I.D to the
defaulted keypad. Keypad I.D's are allocated
incrementally.
3.
The I.D of any keypad can be interograted by viewing the data in
location 446 from the keypad of interest.
12
IDS1632 INSTALLER MANUAL NO. 700-256-02C ISSUED JUNE 2005 VER 1.01
a f
u
t l
n i
g
K
e
y
p
a
d
s
Advertisement
Need help?
Do you have a question about the IDS1632 and is the answer not in the manual?
Questions and answers