Siemens SIMODRIVE 611U Product Information page 31

SIMODRIVE 611U
This speed must be specified in the P880 parameter.
This specifies the scaling of the PROFIBUS speed value. For the maximum speed, a
setpoint NSET = 4000 0000 hex is transferred to the drive via the PROFIBUS. The P880
parameter is used to inform the SIMODRIVE 611U which speed should be set when NSET =
4000 0000 hex.
● The encoder is configured in the next windows.
The absolute value encoder must be configured as ENDAT encoder, e.g. EQN 1325 as
ENDAT (refer to the following two figures).
Figure 4-20
Connecting the SIMODRIVE 611U to the Technology CPU
Product Information, 03/2008, A5E00272066-05
Axis configuration in S7T Config (selects the encoder type for absolute encoders)
Commissioning
4.4 Setting up a STEP 7 project
31