Donning And Fitting - Hollis LTS Series Owner's Manual

DONNING & FITTING
Before any dive make sure that your BCD System fits properly. With your required exposure suit on, don
your BCD System. Make sure it fits comfortably, but is not too tight around your shoulders, waist, and
crotch (when using a crotch strap). Two fingers laying flat should fit snugly between the shoulders and
webbing. Make any adjustments as necessary. Adjust the D-rings and clips to your desired position. A
good starting point is a position where you can reach your chest, with your hand held flat horizontally,
and holding your arm and hand parallel to the ground. Fine tune the fit as needed.
NOTE If you have any questions regarding your Hollis gear, visit your authorized
Hollis retailer or contact Hollis Inc. and speak with one of our technical support
representatives.
23