Instructions For The Installer - Electrolux 65 G Instruction Booklet

Instructions for the Installer

Installation
It is important that all operations are carried out by qualified
personnel, in the normal manner.
The specific instructions are describred in the chapter on
installation.
Before using the unit, take off the special protective layer which
protects the stainless steel and anodyne tin parts.
The following instructions are meant for a qualified installer, in
order that the operations of installation, regulation, and service
are executed according to the existing regulations.
Whenever changes are mode involving the disconnection of the
machine it is necessary to proceed with maximum caution.
THE MANUFACTURING COMPANY DECLINES ANY
RESPONSABILITY FOR POSSIBLE DAMAGES
RESULTING FROM AN INSTALLATION WHICH
DOESN'T COMPLY WITH THE RULES IN FORCE
Installation Environment
Warning - This unit can be installed and can work only in
constantly ventilated rooms, according to rules in force. In order
to make the gas unit work properly, it is necessary that air
sufficient to gas combustion can naturally flow in the room. (The
installer must follow the rules in force).
Positioning
This appliance belongs to the class "X".
It has been designed to be placed close to furniture units not
exceeding the height of the working level (EN 60 335-2-6).
Levelling
The appliance is provided with adjustable small feet placed in
the back and front corners od the base.
By adjusting the small feet (Fig. 17) it is possible to change the
height of the appliance so as to ensure a better levelling with
other surfaces and a uniform distribution of the liquids contained
in pans or pots.
Balancing the lid
The models provided with crystal lids are equipped with specially
balanced springs, inserted in the hinges at the back of the
appliance, to allow the lid to be closed smoothly and easily.
You can use a screwdriver to adjust the closure of the lid. The
necessary force for opening/closing the lid can be increased by
turning the adjusting screw 2 or 3 times as shown in Fig. 18.
Warning! The crystal lid can splinter when
overheated. Always ensure all the burners are
off before closing it.
Lid cleaning (65 G - 66 GS - 95 G)
The cooker lid can be disassembled to allow a better cleaning
(Fig. 20). After a proper cleaning, carefully reposition the lid into
its hinges.
14
All manuals and user guides at all-guides.com
FO 0063
Fig. 17
FO 0064
Fig. 18
Feet Assembly
Before installing the cooker, it is necessary to
assemble the supplied feet. You can find them into
the oven cavity.
1. Remove the hob pan supports, the burner caps and
crowns and the oven accessories.
2. Carefully lean the cooker on its back (Fig. 19), paying
attention not to cause any damage.
3. Adjust the feet height by unscrewing the bottom part of
each foot, until you obtain the required height (height can
be adjusted from 850 to 880 mm).
4. Screw the feet into the relevant supports indicated in Fi-
gure 19.
5. Lift the cooker in vertical position. Replace the crowns,
the burner caps, the hob pan supports and the oven
accessories.
6. If necessary, adjust the cooker horizontal levelling by
turning the bottom part of the feet, until the appliance is
completely stable.
Fig. 19 FO 2283
Fig. 20
FO 0418