Operating Modes - Telex AUDIOCOM BP-2000 Operating Instructions Manual

Local Power Input (BP-2000 only)
Normally the BP-2000 is powered from the intercom
system and will turn on with the intercom system. The
BP-2000 belt pack may also be powered from an optional
power supply (14-30 VDC) connected between pin 2 (+)
and pin 1 (-) of the intercom channel connector.
8.
@PARAINDENT = Intercom Channel Connectors
On the BP-1000, the intercom channel is connected via a
pair of 3-pin connectors (one male and one female). The
male and female connectors are wired together in parallel,
providing a "loop through" at each connector pin. Use
one connector to connect to the intercom channel. Use
the other connector to "daisy chain" a cable to the next
belt pack or other station on the channel.

OPERATING MODES

The microprocessor within the BP-2000/BP-1000 controls four
modes of operation that affects the Microphone Kill and
Audible Call Alert features.
TABLE 1. OPERATING MODES
MODE
(beeps)
1
2 (Default)
3
4
Changing Modes of Operation:
Perform the following steps to change the mode of operation.
1. Both the Talk and Call indicators should be off.
MIC KILL AUDIBLE
CALL ALERT
Disabled Disabled
Enabled Disabled
Disabled Enabled
Enabled Enabled
7