Tyre Pressure Monitor; Wheel Bolt Cover Caps; Full Wheel Frame - Skoda KAMIQ 2020 Owner's Manual

Hide thumbs Also See for KAMIQ 2020:
Table of Contents

Advertisement

Tyre diameter in inches
D
This information only serves as information for
the prescribed tyre pressure. This is not a listing
of approved tyre sizes for your vehicle. These
are listed in the technical vehicle documentation
and in the declaration of conformity (in the so-
called COCDocument).
Tyre pressure reading for the front axle tyres
E
Tyre pressure reading for the rear axle tyres
F
Prescribed tyre pressure value for the emergen-
G
cy wheel

Tyre pressure monitor

Functionality
The tyre pressure monitoring indicator indicates a
change in tyre pressure.
Warning when pressure changes
illuminates
Stop the vehicle.
Check the tyres and tyre pressures.
Show tyres with modified pressure
In the following menu, select the menu item for
displaying the tyre condition.
Or:
Function restriction
The system is unable to provide a warning in the
event of a very rapid tyre pressure loss, e.g. sudden
puncture.
The system function may be restricted in the follow-
ing cases.
Uneven loading of the wheels, e.g. with a trailer at-
tached.
Sporty driving style.
Driving on dirt roads.
Snow chains fitted.
Saving tyre pressure values
Store the tyre pressure values in the infotainment
Inflate the tyres to the prescribed inflation pres-
sure.
Turn on the ignition.
In the following menu, select the menu item for
displaying the vehicle condition.
Wheels ›
Tyre pressure monitor
Or:
Using the functional surfaces
control display menu.
Tap on the functional surface
Then follow the instructions on the screen.
Save the tyre pressures in the following cases.
Change of tyre pressure.
Change of one or more wheels.
Change of position of a wheel on the vehicle.
Always after covering a distance of 10,000 km or
once a year.
Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
Stop the vehicle, switch off the ignition and
start the engine.
If the
symbol flashes again after starting the en-
gine, there is a system fault.
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.

Wheel bolt cover caps

Remove cover caps and install
Disconnecting
Push the pull-off clamp onto the cover cap up to
the stop.
Remove the cover cap.
Installing
Push the cover cap onto the wheel bolt to the stop.

Full wheel frame

Removing and installing the trim
Applies to factory built or original accessory trims
from ŠKODA.
157
select the tyre
.

Advertisement

Table of Contents
loading

Table of Contents