Table of Contents
Advertisement
Replace light bulbs
What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
NOTICE
Danger of headlight damage due to the ingress of
water and dirt!
Always fit the protective cap on the headlight cor-
▶
rectly after changing a bulb.
Conditions for changing a bulb
✓ Ignition switched off.
✓ Light switched off.
Rear turn signal
Lighting, windscreen wipers and washers ›
›
Remove the cover with
the bracket from the
tool kit.
›
Unscrew the screws
and remove the
A
light.
›
Insert the connector into the light until it clicks into
place.
›
Insert the pins
of the light into the openings
A
in the body.
NOTICE
Risk of damage to the electrical system!
Make sure that the cables between the light and
▶
the body are not pinched when the light is inserted.
›
Screw the light into place.
›
Fit the cover of the light, ensuring it clicks into
place.
Replace light bulbs
45
›
Press the lock mecha-
nisms on the connec-
tor and remove the
connector.
›
Turn and remove the
socket with the bulb.
›
Change the bulb in the
socket.
›
Insert the socket with
the new bulb into the
light so that the guide
lugs on the socket are
aligned with the corre-
sponding openings in
the light.
›
Turn the socket clock-
wise
to secure.
B
Advertisement
Table of Contents
