Table of Contents
Advertisement
1.3.3
Using the Bluetooth GPS Receiver
Make sure that your TeleType Bluetooth GPS Receiver is connected to your host device.
1.
Run the TeleType GPS software.
2.
Make sure the appropriate *_place.ttm file for your country is loaded. Go to File > Load > Load
maps, find the directory your *_place.ttm file is located in, and load it. For example, if you were in
the US, you would load the US_place.ttm file.
3.
Go to Tools > Find. Select Address.
4.
Enter information for only the city and state, then select the appropriate country. Select Find. Pick
your city from the list and select Go To. On the following screen, select GPS Initialization.
© 2003 TeleType GPS
v092003
Bluetooth GPS Receiver
v122003
12
Advertisement
Table of Contents
Need help?
Do you have a question about the Bluetooth GPS Receiver and is the answer not in the manual?
Questions and answers