Krups Espresso Automatic EA84 Series Manual page 7

IFU_KR_EA84_EE_NEW_EST 30/05/13 17:52 Page9
Electrical power supply
Danger: Non-compliance with these instructions could cause fatal injuries due to elec-
tric shock!
Please check that the supply voltage indicated on the name plate of the appliance
corresponds to your electrical installation. The appliance should always be plugged into a
socket outlet with an earth connection.
Check that the socket outlet can be easily accessed so that the plug can be disconnected
easily in the event of a malfunction or during a thunderstorm for example.
For the safety of your appliance, remove the plug in the event of a thunderstorm. Do not
pull the power lead to remove the plug.
Remove the plug immediately if you notice any problem during operation or if there is a
problem during percolation.
Disconnect the appliance if you are not going to use it over a long period and when cleaning.
Do not use the appliance if the power cord or the appliance itself is damaged. If the power
cord or plug is damaged, the power cord must be replaced by an approved KRUPS centre.
Do not leave the power cord overhanging a table or work surface. Do not leave your hand
or power cord on hot parts of the appliance.
The power cord must never be close to or in contact with a source of heat or resting on
sharp edges.
The use of multiple plugs or extension leads is not recommended. Any error in connection
will invalidate the guarantee.
Appliance
With the exception of cleaning and descaling according to the appliance's instructions, any
intervention on the appliance must be performed by an approved KRUPS centre.
For your own safety, only use approved KRUPS accessories and spare parts since these
are suitable for your appliance.
Disconnect the appliance when you leave the room or house for a long period of time.
Never open the appliance. Caution, risk of death due to electrical current! Any unauthorised
opening of the appliance will negate the guarantee. Do not use your appliance if it is not
working properly or if it has been damaged. In this event, it is recommended that you get
the appliance examined by an approved KRUPS centre (refer to the list in the KRUPS
service booklet).
For safety and accreditation reasons, any transformation or modification of the appliance,
performed individually, is forbidden, as only tested appliances are accredited and the
manufacturer will refuse all liability in the event of damage.
For safety reasons, while producing steam for making a cappuccino, heating milk or heating
water, take care not to put your hand under the steam nozzle or the super cappuccino
accessory, or under the coffee nozzle while making coffee.
The steam spout can be very hot, take care not to handle it during or just after use.
To avoid dirty water overflowing onto your work-top or running the risk of burning yourself,
remember to fit the drip tray and make sure you protect your work-top during the descaling
cycles, particularly if it is made of marble, stone or wood.
Never put ground coffee into the coffee tank.
Do not put water in the coffee beans tank.
9