Table of Contents
Advertisement
MIX 56 User Manual
Retainer
Clip Screws
Mounting Post
Washer
Mounting
Post Hole
122188-10 A0
Telect, Inc.
Hinge Screws
3.
Insert a mounting post through a washer and into a mounting post
hole on either side of the pin blocks, as shown below.
4.
Using a 3/16 nut driver or a wrench, tighten the mounting post until
it is securely attached to the chassis.
5.
Repeat Steps 3 and 4 on the other side of the pin blocks.
6.
Gently place the holes on the back of the RJ Connector Retrofit
over the wire-wrap pins and carefully push the unit into place, as
2 Installation
Retainer
Clip Screw
Access Holes
Door
Mounting Post
Washer
Mounting
Post Hole
2-17
Advertisement
Table of Contents
