Table of Contents
Advertisement
MIX 56 User Manual
122188-10 A0
Telect, Inc.
Type of Ground
Switch Position
Logic
(M13 Card Circuitry)
DS3 Coaxial Shield
Tx
DS3 Coaxial Shield
Rx
3.
Connect two 75 ohm BNC cables to the connectors marked DS3 In
and DS3 Out, as shown below.
4.
Connect an RJ-45 cable to the Ethernet port, as shown below.
If you are connecting the MIX 56 to an Ethernet Hub, use a "straight"
Ethernet cable. If you are connecting directly to a Network Management
System (NMS) PC, use a "crossover" Ethernet cable.
Configure the network port as half duplex to match the MIX 56 Ethernet
port.
5.
Connect external alarms to the Critical, Major, and Minor alarm
contacts by pressing and holding the spring clip, inserting the wire,
and then releasing the spring clip.
See the illustration on the next page.
On (Default)
Connected to chassis ground
Off
Not connected to chassis ground
On (Default)
Connected to chassis ground
Off
Not connected to chassis ground
On (Default)
Connected to chassis ground
Off
Not connected to chassis ground
NOTE
2 Installation
Definition
75 ohm BNC
Connectors
RJ-45 Ethernet Cable
2-11
Advertisement
Table of Contents
