Advertisement
Motor settings
2
5
6
- Insert the lower cable 2 into the cable stop on
the cylinder.
- Start adjusting the lower cable tensioner by
unscrewing the nut 5 until it abuts on the sleeve
stop.
Do not continue to tighten the cable, tighten only
until the stop is no longer pulling (WITH FORCE)
attempting to move the sheath toward the rear of
the bike, stop adjusting at this time.
- Tighten the nut then 5, 1 full turn = 1mm
- The measurement between the tensioning
cable crimping sleeve and bottom of the
cylinder sheath should be 0.5 mm minimum,
1mm maximum when pulling (WITH FORCE) on
the cable to the rear of the bike, if this
measurement is not correct, correct by
tightening or loosening the nut 5.
- Tighten the nut 6 against the stop.
- Lubricate with spray grease the cables on the
pulley, the pulley groove and the steel plate to
prevent oxidation.
91
Advertisement
