Advertisement
250-300 SE/R
Motor settings
ADJUSTING THE TENSION OF THE VALVE CABLES
1
2
3
1
90
- Make sure that the tensioning cables are
completely relaxed.
- Adjust the top position on the cable
pulley 1 at the stop located on the cylinder.
- For the present time do not adjust the lower
cable 2.
- Turn the bike ignition switch ON.
- Wait until the electric motor initializes the
valves and then shuts down.
-Turn the bike ignition switch OFF.
- Start adjusting the upper cable tensioner
3 by unscrewing the nut from the sleeve stop.
Do not continue to tighten the cable, tighten only
until the stop is no longer pulling (WITH FORCE)
attempting to move the sheath toward the rear of
the bike, stop adjusting at this time.
- Note: In this configuration, the central valves
must be fully lowered.
- Then tighten the nut 1, 1 full turn = 1mm
- The measurement between the tensioning
cable crimping sleeve and bottom of the
cylinder sheath should be 0.5 mm minimum,
1mm maximum when pulling (WITH FORCE)
on the cable to the rear of the bike, if this
measurement is not correct, correct by
tightening or loosening the nut 1.
- Tighten the nut 4 against the stop.
4
Advertisement
