Installing The Sneeze Guard - Hatco GLO-RAY GRHW Series Installation And Operating Manual

INSTALLATION
GRHW-1SGD and GRHW-1SGDS Models
1. align the four holes in the sneeze guard and support trim with
the four studs located underneath the front top of the unit.
2. Secure the sneeze guard and support trim to the studs with the
four supplied cap nuts. Do not over-tighten the cap nuts.
Sneeze Guard
Support Trim
Figure 10. Installing a Sneeze Guard
(GRHW-1SGDS model shown)
Installing the Side Panels
Some models are shipped with side panels. Use the appropriate
procedure to install side panels on a unit.
GRHW-1P, -2P, -1SG, and -1SGS Models
The above models can be equipped with polycarbonate side
panels. To install a polycarbonate side panel:
NOTE: Make sure to install the sneeze guard before installing
side panels, if equipped.
1. align the four holes in the side panel with the corresponding
holes in the two support posts.
• make sure the slanted edge of the side panel is aligned
with the sneeze guard.
2. Secure the side panel to the support posts using the four
Stud
Cap Nut
GRHW-1SGD and GRHW-1SGDS Models
all GRHW-1SGD and GRHW-1SGDS models are equipped
with glass side panels. To install a glass side panel:
1. Slide the top of the glass side panel up into the upper
2. align the bottom of the glass side panel with the lower
NOTE: Side glass panels have a special "Low E" coating
8
supplied screws. Do not over-tighten the screws.
Polycarbonate
Side Panel
Screw
Figure 11. Polycarbonate Side Panel Installation
(GRHW-1SG model shown)
channel.
channels, then lower into position.
Glass
Side
Panel
"OUT"
Facing
Outward
Figure 12. Glass Side Panel Installation
(GRHW-1SGDS model shown)
applied to one side to help reduce heat loss through the
glass. The "Low E" coated side must face inward and
the word "OUT" on the glass must face outward.
Support
Post
Form No. GRHWm-0111