Installation Safety; Installation Contents: Bollard And Evse; Power Xpress Evse (El -50600-300) For Bollard Charge Station; Bollard And Hardware (El-50600-500) - Bosch Power Xpress Installation Instructions Manual

en | 2 | Power Xpress™ Dual Bollard Charge Station Installation Guide

1.0 Installation Safety

SAVE THESE IMPORTANT SAFETY INSTRUC-
TIONS
This guide contains important instructions
that must be followed during the installation
of the electric vehicle supply equipment
(EVSE). All instructions should be carefully
read before installation of the EVSE.
WARNING: Turn OFF the circuit breaker
at the service or distribution panel before
performing any electrical work or repairs.
WARNING: The EVSE should be installed by
a licensed electrician in accordance with
all local electrical codes and ordinances,
and all authorities having jurisdiction.
WARNING: Do not install the EVSE near
flammable, explosive, or combustible
materials. Do
flammable, explosive, or combustible
materials near the EVSE.
WARNING: Improper installation of the
EVSE can result in personal injury or
product damage.
WARNING: This EVSE installation guide
is not a substitute for electrical safety
precautions.
WARNING: Use this EVSE within the
specified operating parameters. Failure
to do so may result in injury or death.
WARNING: Locate and install this EVSE in
a location where the charge cable will not
be stepped on, tripped over, or subject to
damage or stress.
WARNING: The EVSE must be connected
to a grounded, metal, permanent wiring
system, or an
conductor must be run with the circuit
conductors and
equipment grounding terminal on the
EVSE.
CAUTION: Incorrect installation of the
576414 | REV. B | 28.10.2016
not locate or store
equipment-grounding
connected to
EVSE can result in damage to the vehicle's
battery and to the Charge Station itself.
These damages will void the warranty for
the vehicle and the EVSE.
CAUTION: Do not operate the EVSE in
temperatures beyond its operating range of
-40°F to +122°F (-40°C to +50°C).
2.0 Installation Contents:
Bollard and EVSE
(EL-50650-XXXX)
2.1 Power Xpress EVSE (EL-50600-300) for
Bollard Charge Station x2

2.2 Bollard and Hardware (EL-50600-500)

the
Bosch Automotive Service Solutions Inc.