The Radio; Sequential Tuning - Technics SA-DA10 Operating Instructions Manual

FM MODE, EON
1
2
BAND
3
TUNING
PTY SELECTOR
28
RQT5518
2 3 1
VGCA
INPUT SELECTOR
Selected band
TUNED STEREO
SPEAKERS
A

The radio

Sequential tuning

Use the tuning buttons to tune-in radio stations.
1
Turn [INPUT SELECTOR] to select
"TUNER".
2
Press [BAND] to select "FM" or "AM".
3
Press [TUNING ,
SELECTOR] (for the United Kingdom)
or [TUNING ,
New Zealand) to tune to the desired
frequency.
"TUNED" lights up when tuned.
"STEREO" lights up when an FM stereo broadcast is
received.
To make an automatic search for stations
Hold down [TUNING,
United Kingdom) or [TUNING,
New Zealand) until the frequency begins to scroll. Tuning
stops when a station is found. (Tuning may stop if there is
interference.)
If noise is excessive in the FM stereo mode
Press [FM MODE, EON] (for the United Kingdom) or [FM MODE]
MHz
(for Australia and New Zealand).
("STEREO" will go out, and "MONO" will light up).
The broadcast will be monaural, but noise will be reduced.
If the button is pressed once more, the stereo mode resumes.
If there is hissing or thumping while the radio is
playing
Turn VGCA on.
This turns DSP off and can improve sound.
(\ Page 27 for details about VGCA.)
For your reference
The tuner can pick up interference from DVD players. If this
occurs turn the DVD player off.
To change the AM frequency step
MHz
Press and hold [BAND] for about 3 seconds when AM band is
selected. (The frequency step changes from 9 kHz to 10 kHz.)
To return to the previous step, press and hold [BAND] for about 3
seconds again.
, , PTY
, ] (for Australia and
, , PTY SELECTOR] (for the
, ] (for Australia and